Boot Build

Tim_GTi · Post by **Tim_GTi** » Wed Jan 02, 2008 7:48 pm

sorted wrote:http://s195.photobucket.com/albums/z92/ ... 20Install/

looking good neil

, but just how how much extra weigh does that add? is it heavier than the back bench?

adam_0612 · Post by **adam_0612** » Wed Jan 02, 2008 11:06 pm

how did u stick the carpet down, with glue and staples???
also where did u buy it from? will a local halfords sell it?

Tim_GTi · Post by **Tim_GTi** » Thu Jan 03, 2008 6:59 pm

adam_0612 wrote:how did u stick the carpet down, with glue and staples???
also where did u buy it from? will a local halfords sell it?

Have you checked eBay? i'm sure they'll do it on there

kipper · Post by **kipper** » Thu Jan 03, 2008 8:25 pm

the carpet i believe u can get from most car shops as in halfords c.a.r etc. they should do they spray adhesive to. or u can normally get carpet spray adhesive from most if not all diy stores. u can always then use blue tacks (small nails with slightly bigger heads) not clout nails, and use them to nail the left over material on the underneath the board. thats how i do and it works great

Dee-vub · Post by **Dee-vub** » Tue Jan 08, 2008 4:37 pm

Looks decent buddy! Nice little subtle set up! Perfect for the polo

I'm just about to start my build

Bepe · Post by **Bepe** » Tue Jan 08, 2008 5:54 pm

nicer phil, some top gear there mate, keep us posted

the carpet was from halfrauds and so was the spray adhevsive

carpet was Â£25! for 2mx1m and the spray was about Â£5

Tim_GTi · Post by **Tim_GTi** » Tue Jan 08, 2008 6:45 pm

Dee-vub wrote:

haha this pic freaked me right out!!

i thought your sub was a mid range,

the mid-ranges tweeters

and your amp a crossover

then saw your headunit and thought hang about since when did they make them that small?!!!

nice pile of gear

h4r1s · Post by **h4r1s** » Tue Jan 08, 2008 8:08 pm

nice bit of kit that

i want that RE sub

ModifiedMadness · Post by **ModifiedMadness** » Tue Jan 08, 2008 11:25 pm

h4r1s wrote:nice bit of kit that i want that RE sub

Don't fancy this one then?

Bepe · Post by **Bepe** » Tue Jan 08, 2008 11:29 pm

nice install that but not keen on how the cables are

h4r1s · Post by **h4r1s** » Wed Jan 09, 2008 12:56 pm

ooo is that the mxd1 ain't it? 1600wrms

i would but i need my boot space

been looking at the SE12v4 i think it is, but there's something going on with REaudio, they are supposedly not distributing anymore or something like that.

Tim_GTi · Post by **Tim_GTi** » Wed Jan 09, 2008 6:39 pm

you selling it Tom?

ModifiedMadness · Post by **ModifiedMadness** » Wed Jan 09, 2008 7:15 pm

h4r1s wrote:ooo is that the mxd1 ain't it? 1600wrms i would but i need my boot space been looking at the SE12v4 i think it is, but there's something going on with REaudio, they are supposedly not distributing anymore or something like that.

I've got the MX12 D2 wired to 1ohm and getting 1500w RMS which is what it's rated at. I'd love to give it 2000 RMS though

RE are still distributing, they're sold through Car Audio Direct or you can go through Blade Ice who are the European Distributors of RE Audio, you can get them on 01908 610441.

Tim_GTi wrote:you selling it Tom?

No chance

Dee-vub · Post by **Dee-vub** » Sat Jan 12, 2008 9:03 pm

Yeh tom i defintely did want that one, but i just couldnt stretch my budget that far i'm afraid

This one should do the job, i'm not after a competition install......Just a better than average install, which i know this will be.....just need to get the wiring kit and deadening and it will be cracked on with

ModifiedMadness · Post by **ModifiedMadness** » Sun Jan 13, 2008 4:16 pm

Is it the SE you've got Phil? I had the newer version and that did the job nicely off 450w RMS.

I'd love to give mine more really, think I'll need a better battery at some point too!