6n2 Gti door lock pin and bezel

mmh · Post by **mmh** » Wed Jan 16, 2008 2:39 pm

Hi,

Does the Polo Gti 6n2 have an alarm LED in the door lock pin bezel on both the passenger and drivers side?

Also do the lock pins go flush with the bezel when down (like on the Golf mk4 etc)?

Finally if anyone could give me a part number for these it would really help me out.

Cheers

ModifiedMadness · Post by **ModifiedMadness** » Wed Jan 16, 2008 2:50 pm

Only has the flashing LED on the drivers side mate, and unfortunately the pins don't go down flush when the car is locked

Tim_GTi · Post by **Tim_GTi** » Wed Jan 16, 2008 3:07 pm

you can make the pins sit flush easily, i have done so with my pins

heres the guide

http://www.tigerstyle.co.uk/poloforum/v ... =door+pins

you just unscrew them, snip the wire about 5mm and put the pins back on, you dont even need glue they stay on there fine without!

mmh · Post by **mmh** » Wed Jan 16, 2008 4:57 pm

Cheers Tim and Modified,

I don't suppose you know the part number for the LED bezel and the door lock pin?

I'm going to VW tomorrow but the parts people in there are terrible if they are not spoon fed VW part no.'s they don't give a "Â£$% and make it such a long effort for them to search it out on their catalogue.

Cheers,
Mahbs

h4r1s · Post by **h4r1s** » Wed Jan 16, 2008 5:19 pm

i've got that led and bezel if you want to buy it off me?

mmh · Post by **mmh** » Thu Jan 17, 2008 1:49 am

Hi Haris,

If you have a pair I'd take them off you. How much were you ater for them?

Cheers,
Mahbs

h4r1s · Post by **h4r1s** » Thu Jan 17, 2008 11:36 am

i've only got one, but you can have this one for Â£8 delivered

JKM_GTI · Post by **JKM_GTI** » Thu Jan 17, 2008 10:52 pm

h4r1s wrote:i've only got one, but you can have this one for Â£8 delivered

I've got another one which you can have for the same, making the two

mmh · Post by **mmh** » Sat Jan 19, 2008 11:36 am

Hi,

Thanks for your replies.

Would someone be kind enough to measure the length and the width of the bezel as well as the diameter of the lock pin hole.

I need the info as I'm going to put them on my 6n, however, the area around the drivers side lock pin hole is a bit ragged so would like to make sure the bezel would cover it to give a nice clean look.

Cheers,
Mahbs

h4r1s · Post by **h4r1s** » Sat Jan 19, 2008 11:47 am

will do so today mate, sorry not had the chance hence the reason for not replying to your pm yet.

mmh · Post by **mmh** » Sat Jan 19, 2008 12:20 pm

Cheers Haris, top man.