badges

Glover12 · Post by **Glover12** » Mon Apr 21, 2008 9:46 am

Ive just bought these badges http://cgi.ebay.co.uk/VW-POLO-MK4-6N-94 ... dZViewItem to put on my polo mk4 (6n) and dont really no how to unclip the front one, i dont want to break the original so didnt want to force it out.
i also know thanks to the forum that i have to heat the badge on the boot up then get under it with a flat edge.Is this correct?
When putting the new badge on the boot or equally the front shall i rough up the area and whack a bit of grab adhesive on to make sure the new badge will stay secure?

Cheers in advance

randomage · Post by **randomage** » Mon Apr 21, 2008 10:26 am

you're right with how to remove the back badge. the front simply pulls out. give it a good haul and itll pop out easy enough. if you're worried about breaking things, hold the grille in while you do it.

Polo96CL · Post by **Polo96CL** » Mon Apr 21, 2008 12:05 pm

Do not pull the front out!

It is held in place by 3 clips, these are accessed by lifting the bonnet, using a flat headed screwdriver to unclip 4 clips which attach the top of the grille, then put your hand down behind the grille and unclip the 3 clips which attach the front badge.

NOZ · Post by **NOZ** » Mon Apr 21, 2008 1:23 pm

^^ thats the best and easiest way to do it. Hauling it out may break the clips

randomage · Post by **randomage** » Mon Apr 21, 2008 1:27 pm

we learn something new every day

i pulled mine out a few times n nothing broke, but i did it carefully, top first then bottom. if that makes any sense.

Glover12 · Post by **Glover12** » Mon Apr 21, 2008 2:44 pm

Cheers guys major help

Should i put adhesive on the back one?