Cheapest Engine Converison?

tegwin · Post by **tegwin** » Wed Apr 23, 2008 10:43 pm

If the driveshafts are the wrong length/gearbox fitting you can have them modified...

I spoke to a company who were quoting Â£30 per shaft for extending them to any length....(Wasnt on a polo, but its the same thing!)

So phone a prop/driveshaft specialist if you need shafts and ask them!

1der · Post by **1der** » Wed Apr 23, 2008 10:44 pm

im presuming it was a crash damaged ibiza you got?

tomo87 · Post by **tomo87** » Wed Apr 23, 2008 10:54 pm

1der wrote:im presuming it was a crash damaged ibiza you got?

ive found one...so if all goes to plan yes

why?

going to run a K03s turbo though for a little extra power

bbspolo · Post by **bbspolo** » Wed Apr 23, 2008 11:02 pm

cheers mate but i know u can have shafts made/ moddified i had 4 custome ones made for my cosworth, i was just wondeing if he had found a off the shelf one 2 use! but thanks anyway

the mounts are provin 2 be the hardest point and without modifing the inner arches i dont think any seat ones fit ! would like 2 be proved wrong though!

Dee-vub · Post by **Dee-vub** » Fri Apr 25, 2008 9:42 am

I'm fairly certain, the drive shafts is one of the issues needing recitified! not tough though with the help of a specialist though

Tom i just remembered i have to pm you back on CP. I'll do it tonight though, cos im on nightshift and just away to my bed pal!

tomo87 · Post by **tomo87** » Fri Apr 25, 2008 9:51 am

ye driveshafts and mounts are the main issues.....

ok phil no worries

1der · Post by **1der** » Fri Apr 25, 2008 12:49 pm

tomo87 wrote:
1der wrote:im presuming it was a crash damaged ibiza you got?
ive found one...so if all goes to plan yes

why?

going to run a K03s turbo though for a little extra power

just i haven't seen many damaged ones and thought you must be pretty rich to break a good cupra