throttle body size???

BIG4244 · Post by **BIG4244** » Wed Jan 28, 2009 10:55 pm

Hi, just a quick one, what size 90degree bend would i need, i think its a 70mm inside diameter? cheers

Tim_GTi · Post by **Tim_GTi** » Wed Jan 28, 2009 10:56 pm

Throttle body size is 63mm

BIG4244 · Post by **BIG4244** » Wed Jan 28, 2009 10:58 pm

ah right so i need 63mm i.d. pipe work, cheers

Tim_GTi · Post by **Tim_GTi** » Wed Jan 28, 2009 11:01 pm

Ideally yeh, 64mm will fit though, apparently this can be bought on eBay. I would imagine you'd be able to go up to close of 70mm. Just make sure you secure it tightly with a jubilee clip.

BIG4244 · Post by **BIG4244** » Wed Jan 28, 2009 11:04 pm

nice one, cheers for the help

Rossco · Post by **Rossco** » Thu Jan 29, 2009 12:14 am

The bend that holds my CDA is 60mm to the throttle body, it fits, but its a tight fit!

Tigz · Post by **Tigz** » Thu Jan 29, 2009 3:37 pm

Cheapest place for a 90º bend?
Im knocking up a cheap K&N kit from bits from my old Renault.

Tim_GTi · Post by **Tim_GTi** » Fri Jan 30, 2009 10:21 am

Tigz wrote:Cheapest place for a 90º bend?
Im knocking up a cheap K&N kit from bits from my old Renault.

I would say eBay mate

UK-POLOS.NET - THE VW Polo Forum

throttle body size???

throttle body size???

Re: throttle body size???

Re: throttle body size???

Re: throttle body size???

Re: throttle body size???

Re: throttle body size???

Re: throttle body size???

Re: throttle body size???