Guys with Standard Height and Standard Wheels........

Chat about your MKV (6N2) Polo GTi
Post Reply
User avatar
Tim_GTi
Post Whore
Posts: 12289
Joined: Mon Jun 25, 2007 6:31 pm
Location: Newport, South Wales
Contact:

Guys with Standard Height and Standard Wheels........

Post by Tim_GTi »

I'm sure I'm not the only one to hate being asked the question "how low are you?", as being on coilovers you're never quite sure.

I was thinking...

Can someone (Or better still a few people) with a GTi on standard wheels and standard height measure the following:

Floor to the top of the front arch
Floor to the top of the rear arch

As pictured here:
Image

And maybe also

Floor to the bottom of the front splitter (as pictured here):
Image
And the same on the rear bumper?

I think a few people would benefit from the following results, as everyone could get a good indication as to how low they're actually riding

Thanks very much in advance 8) :D
User avatar
BIG RHYS
Gold Member
Posts: 586
Joined: Sat May 17, 2008 1:47 pm
Location: Newport,Wales

Re: Guys with Standard Height and Standard Wheels........

Post by BIG RHYS »

Nice idea tim this will help out loads 8)

car looks mint there 2 mate :D
Si_GTi
Moderator
Posts: 5020
Joined: Thu Apr 08, 2004 1:14 pm
Location: Shropshire

Re: Guys with Standard Height and Standard Wheels........

Post by Si_GTi »

I took some measurements yonks ago the night before my coilovers were fitted. Will have a search and dig them out.

EDIT:

I only took measurements from arch to centre of rim.
Si_GTi wrote:Standard suspension: 34.5cm (Front), 33.5cm (Rear). Measured with a full set of coilovers in the boot.

FK coilovers: 29.5cm (Front), 28.5cm (Rear). Measured with the complete standard suspension in the boot.

Both sets of measurements were taken from the arch to the centre point of the wheel centre cap.
Cheers
Last edited by Si_GTi on Fri Jun 26, 2009 12:06 am, edited 1 time in total.
Reason: Added info from old progress thread re measurements
User avatar
Tim_GTi
Post Whore
Posts: 12289
Joined: Mon Jun 25, 2007 6:31 pm
Location: Newport, South Wales
Contact:

Re: Guys with Standard Height and Standard Wheels........

Post by Tim_GTi »

sweet. that's a good start. I'm gunna get myself onto some flat today and measure mine to compare. cheers mate 8)
User avatar
Joniboy
Getting There!
Posts: 56
Joined: Tue Sep 23, 2008 3:09 pm
Location: Creepy Crawley and Banstead
Contact:

Re: Guys with Standard Height and Standard Wheels........

Post by Joniboy »

Just popped out with the tape measure for you.
Mine is:

Front: 60.9cm from floor to arch.
Rear: 62.1cm from floor to arch.

But using Si_GTi's method (arch to centre of rim):

Front: 35cm
Rear: 35.6cm

Measurments taken on the flat with no weight in the car, half a tank of petrol and all tyres at 32psi.

Hope this helps,
User avatar
Tim_GTi
Post Whore
Posts: 12289
Joined: Mon Jun 25, 2007 6:31 pm
Location: Newport, South Wales
Contact:

Re: Guys with Standard Height and Standard Wheels........

Post by Tim_GTi »

spot on mate, cheers!

Just did mine,

front arch to floor 53.5cm (but just dropped it another 10mm so will be 43.5cm)

rear arch to floor 53.5cm.

So I'm down about 85mm all round, altough my fronts lower than the rear.
User avatar
Joniboy
Getting There!
Posts: 56
Joined: Tue Sep 23, 2008 3:09 pm
Location: Creepy Crawley and Banstead
Contact:

Re: Guys with Standard Height and Standard Wheels........

Post by Joniboy »

No worries - glad I could help while the car is still standard ;)
Shouldn't be too long 'till its closer to the floor!
Post Reply