oil breather

[Jeff GTi]

noticed recently iv been having some oil weaping from my oil breather which is situated under the dump valve

its clearly been doing it for some time, as the back of the block was all oily

so with the engine dropped and the block cleaned up fully, there is no oil leaks from anywhere at all except this breather going from the block to the forge TIP

i have cleaned the joint up and used a new super strong jubilee clamp on it to replace the s**t vw crimp/clamp effort, and some material tape to try and make the joint a better seal, touch wood, its ok so far, just seemed to be a very slack fit on to the forge TIP

anyone else having / had issues with this at all,

before i used the material tape, even with the jubilee clamp on only, it was still weaping oil, really pissing me off, i hate stuff not being right, now, touch wood, its ok, but ill keep an eye out

does anyone like forge etc, do an uprated version which i can buy and use instead, and i dont want an open breather, as it connects to 2 pipes not 1

i must also admit, with the joint strengthened its a hell of a lot harder boost kick now, almost like its been suffering boost loss because of this issue

[loud]

sounds like you need an oil catch tank!

[yorks GT TDI]

INA or 034motorsport which ever they are know as do an uprated set

[VWindahouse]

INA or 034motorsport which ever they are know as do an uprated set

Thanks mate some good stuff at 034!

So will this fit the polo ok then? http://www.034motorsport.com/product_in ... gov14on2f4

Cheers!

[yorks GT TDI]

sure will

[VWindahouse]

Ordered, thanks mate!