carbon sheet

[Gtimatt]

got a sheet of carbon fibre sticker ermm stuff! anyway heres how my vents turned out



before


after

[Dub_Dan]

really like the look of that dude! reminds me of the m sport trim you get in the e46 coupe's nice touch!

[Gtimatt]

really like the look of that dude! reminds me of the m sport trim you get in the e46 coupe's nice touch!

thanks

[blazeguarder]

Looks excellent!

You planning on doing any more or just leaving it at the vents?

[Gtimatt]

Looks excellent!

You planning on doing any more or just leaving it at the vents?

not sure yet, gets more difficult with bigger/more complex items lol. i'll have to think about it. open to suggestions though?

[blazeguarder]

hmmm, maybe the centre console as well? Might be a bit too much though, door pulls perhaps?

[Gtimatt]

hmmm, maybe the centre console as well? Might be a bit too much though, door pulls perhaps?

i had a look at centre console...its huge haha lol, could look good. yeah i might have to have a look at door pull area n see how difficult it is to take apart

[MODDED9N]

Can you send me a link to the carbon sheet you used? Cheers

[matt_123]

looks awsome! Linky also needed for this carbon wrap stuff. the quality on that finish doesnt look too tacky either.

[Gtimatt]

both pm'd

[matt_123]

how do you get the side vents out ? i tried a flat head screw driver but only one side pops out and i dont wana mark anything up by using any more force lol

[Gtimatt]

how do you get the side vents out ? i tried a flat head screw driver but only one side pops out and i dont wana mark anything up by using any more force lol

take off the panel where the fuses are then just push it from behind!!

[ali123]

looks tidy, good job