Hi, new to the forum and slowly finishing minor repairs on my 6n2 before making a few mods.
Had a bit of water get in to car through a window left open, lining of door interior has lifted from wood. Could anyone tell me how to go about removing the interior of the door and sticking the lining back down?
Any help greatly appreciated
Door Interior
Door Interior
6n2 is a mkv fella. Door cards are removed by first taking off the window wonder cover and undoing the screw in tere. Then pop off the front of the grab handle two screws in there easily pops off if you pull te silver door handle out and pop a screw driver in behind there. You need to unscrew the door pin until the comes out. The final screw is on the back of the door round by the tweeter pod. After this pull the card off the clips and then pull over the door pin. Refitting is the reverse pretty easy job.
Re: Door Interior
Cheers for that mate, I thought I might of posted in the wrong place. Haha. Cheers for ya help anyway. Will make sure I post in the right place next time 