Thanks this helped a lot, but how did you run the wires through, is there a need of any drilling, and does the bluetooth module wires just plug into the back of your radio unit?BlackSEL wrote:Hi, I can't help with the radio differences but I have just fitted the 9w7 bluetooth module to the RCD 510
I removed the trim under the glovebox where the little cubby box is and managed to push the module up above the cubby box as it wouldn't fit under the seats (my car has the boxes under the seat). I wrapped the module in foam so there's no rattles.
I ran the wires above the glovebox to the back of the radio.
Hope this helps!
No, no drilling or cutting, I removed the radio and the trim to the side of the glovebox (facing the door). I was then able to push a straightened coat hanger in from the side to the back of the radio slot. I then taped the mic cable and the cable that runs to the module to the coat hanger and pulled it back through.IZVVC wrote:Thanks this helped a lot, but how did you run the wires through, is there a need of any drilling, and does the bluetooth module wires just plug into the back of your radio unit?BlackSEL wrote:Hi, I can't help with the radio differences but I have just fitted the 9w7 bluetooth module to the RCD 510
I removed the trim under the glovebox where the little cubby box is and managed to push the module up above the cubby box as it wouldn't fit under the seats (my car has the boxes under the seat). I wrapped the module in foam so there's no rattles.
I ran the wires above the glovebox to the back of the radio.
Hope this helps!
It depends on which radio you have. If you have a capable radio such as the rcd510 you are able to add a bluetooth module and do the things you mentioned through the radio screenchrispy. wrote:I was under the impression you need to install the little screen..
What im looking to do is:
- Play music from phone through radio
- Take calls through radio
Can anyone clarify what I will need?
Sent from my iPhone using Tapatalk
thanks!I got this one and it works well,chrispy. wrote:Anyone know the exact module ill need? Part number?
Sent from my iPhone using Tapatalk
IZVVC wrote:BlackSEL, i looked through Norbrecks post but couldmt find much hope and was eyeing if you would be able to help me.
So what trim exactly are you talking about in the glove box, would you be able to show me or desrcibe it and how exactly did you take it off, and how did you loom the mic in a good place too, any help and detailed help would be much appreciated thanks!