Bulbs

[Welshgirlx]

What bulbs are the drl? And how easy as they to change ?

[Doc_House]

The DRL's are T20's and takes about 10 - 15 minutes with a bit of care and a torx screw driver (one in the tool kit)

Unhook the trim around the foglight, be gentle as it can be brittle around the tabs... I broke mine the first time around.

Unscrew the fog lamp/ drl unit and disconnect the wires.

Remove the outer DRL lamp and replace, push it in to the holder

Reverse the above to refit and make a cuppa

http://www.horizonleds.co.uk/cree-leds/ ... w-cree-led

[TheFrog]

This was one of the first mods I did. The LEDs look waaaay better than the horrible yellow factory bulbs. However, I went for the 60W version, as these seem to have about the same brightness as the stock bulbs. I've run them for 6 months now and never been flashed by oncoming motorists.

[Welshgirlx]

The DRL's are T20's and takes about 10 - 15 minutes with a bit of care and a torx screw driver (one in the tool kit)

Unhook the trim around the foglight, be gentle as it can be brittle around the tabs... I broke mine the first time around.

Unscrew the fog lamp/ drl unit and disconnect the wires.

Remove the outer DRL lamp and replace, push it in to the holder

Reverse the above to refit and make a cuppa

http://www.horizonleds.co.uk/cree-leds/ ... w-cree-led

Might sound stupid don't laugh but do I have to buy two or is it a set? I would
Of thought a set but it doesn't actually say -.-

[Welshgirlx]

Also, can you do all this from the outside or do I have to like lean into the engine bay hahaha!
I have a torx ready so:)

[Doc_House]

you need a pair of led's and it's all done from the front without getting under the bonnet