Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Ciclo in my model year A I have relay 331 in socket 4 ? and i must use (in your photo) small wire jumper , in this socket is two relays I must remowe left ? and connect pins 3 and 5 toghether.
in fuse box :
34B Split to new wire to T73a/62
39B cut original wire and split to T73b/2
59B cut original wire and split to T73a/2
New wire
39B ---> T73b/68
59B ---> T73A/63
Xenon range unit on the car connected tooday , waiting for leveling sensor only.
The wire T17/3 old now isolated is connected to old DRL (non led) in fog lamps , I use this wire with new relay for new instalation with auto switch (not needed to add new wire T73a/7 ---> T17/8 ---Ne wire Fuse 15A--- FOG) I planned use it with AUTO switch T10/5 ---> relay ---> FOG Right ?
Where is pin for xenon washer pump ? , i have planed wire for this.
Many thanks for understanding (better ask before replace instalation) and best regards Chriss
Ciclo in my model year A I have relay 331 in socket 4 ? and i must use (in your photo) small wire jumper , in this socket is two relays I must remowe left ? and connect pins 3 and 5 toghether.
RekinPoznan wrote:
The wire T17/3 old now isolated is connected to old DRL (non led) in fog lamps , I use this wire with new relay for new instalation with auto switch (not needed to add new wire T73a/7 ---> T17/8 ---Ne wire Fuse 15A--- FOG) I planned use it with AUTO switch T10/5 ---> relay ---> FOG Right ?
Rewiring done , now DRL LED , and another functions works fine , many thanks for the support
Thanks to you for sharing.
Please make a brief summary of what you've installed and is functioning properly. I do not remember the whole state (installations) of your 6R.
Hi ciclo, I have adopted iichel's solution, and now everything is working perfectly. thanks to both of you.
One last question, where you have placed the resistors? because they really heat up!
Last edited by Bachecco on Sun May 22, 2016 4:36 pm, edited 1 time in total.
Hi ciclo, I have adopted iichel's solution, and now everything is working perfectly. thanks to both of you.
One last question, where you have placed the resistors? because they really heat up!
Hello, Fernando and everyone!
I've started a facelifting mod to 6C look. Additionally retrofit headlight washers and front PDC.
Next step is 6C headlights and grill retrofitting.
Now question is concerning headlight washer adaptation. What adaptation channels of 09 Cent.Eletr. change washer running time and frequency?