Golf 7.5 Installation of the washer fluid level sensor G33. Preliminary studies.
I found 3 different 3 liter washer fluid reservoirs with the same part number, I assume they will have different PR codes, but they are not available from ETKA online (ifinterface).
![Image](https://i.imgur.com/aHmw2cE.jpg)
The one installed in my wife's Golf is the one without hole.
I have read that the hole for the sensor has a diameter of 26 mm, but in case I install the level sensor in the 3L reservoir I will do tests about the diameter to be drilled.
![Image](https://i.imgur.com/VyV5TOz.jpg)
(waiting for sensor, wiring and seal from Ali)
Some pictures of the 3L reservoir:
The following image was taken from youtube.
https://www.youtube.com/watch?v=N5dJP66yqec (thanks)
In case of installing a new 5L reservoir, these are the necessary parts:
![Image](https://i.imgur.com/HQgKjDS.jpg)
- The stopper/plug and seal replace the pump for vehicles with headlight wash system.
- Main pump seal.
- Pipe and adapters to lengthen the ones that are installed.
Wires.
The connection is quite simple, one wire -1- to earth (near the reservoir) and the other wire -2- to the BCM
T46b/28 (MQS terminal).
I should have done this installation when I installed the 8IU LED headlights.
![🙊](//cdn.jsdelivr.net/gh/twitter/twemoji@latest/assets/svg/1f64a.svg)
It is true that I thought about it at the time, but since it is a very simple installation, will serve me as a hobby/project for the summer season.
![😊](//cdn.jsdelivr.net/gh/twitter/twemoji@latest/assets/svg/1f60a.svg)