Kenwood 17cm components KFCPSR71P what amp?

James0121 · Post by **James0121** » Sun Oct 17, 2004 7:30 pm

hey there im getting a set of Kenwood 17cm components KFCPSR71P for my 1998 6n polo. They are rated at 200 W peak power ne1 got any ideas of what sized amp i need ? as i havent got a clue

any help would be gladly appreciated

cheers

James

sylonien · Post by **sylonien** » Mon Oct 18, 2004 3:47 am

What's the RMS power rating?

James0121 · Post by **James0121** » Mon Oct 18, 2004 4:54 pm

i have been looking for th rms power but cant seem to find it on any of the web sites which i have looked. im sure there going to need an amp as i have read that these speakers draw alot of power espically with the cross overs. oh yea any idea where i can mont the cross overs easily ?

david burton · Post by **david burton** » Mon Oct 18, 2004 5:33 pm

peak is usually double the rms - so say 100W

i'd look for at least a 50Wx2 amp rated RMS at 4ohms (not 2ohms). anything less will be a bit of a waste of time.

does that help?

James0121 · Post by **James0121** » Mon Oct 18, 2004 7:43 pm

awww right. so an ampwith the following spec would be fine??
Or could it be to much?

#High quality 4-channel power amplifier
#640Wmax power
#60W x 4 (4 ohms) RMS
#180W x 2 (4 ohms) RMS

ne ideas where to put cross overs do i mount them in the boot or do i fit them in the doors ?

bit of a novice as u can tell.

david burton · Post by **david burton** » Mon Oct 18, 2004 7:47 pm

that looks fine, power rating vary a lot by the way - so as long as it's a good make you'll be ok.

if the tweeters are small, mount the crossovers in the space where the current speakers are - otherwise just shove em above the footwell somewhere - you can easily wire em up from there.

James0121 · Post by **James0121** » Mon Oct 18, 2004 7:53 pm

awww right cheers. sounds good was a kenwood amp they seem to do some pretty good stuff.