How do I get the ignition key lock off?

Chat about your 6R/6C model Polos here!
Post Reply
dazz
New
Posts: 30
Joined: Sat May 21, 2016 10:54 am
Drives: Polo 6R Comfort Line 2010
Location: New Zealand

How do I get the ignition key lock off?

Post by dazz »

Hi
I have the VW broken ignition lock problem with the stuck key.
I am trying to remove the plastic coverings between the steering wheel and the instrument cluster.
The top half is flapping around, but held in place by the instrument cluster.
I can't figure out how to release the bottom half. I have found the Torx screw.

Any tips would be appreciated.
amer6R
Platinum Member
Posts: 1300
Joined: Thu Feb 06, 2020 7:57 am
Drives: Polo 6R 2010 1.6 TDI
Location: budget build

Re: How do I get the ignition key lock off?

Post by amer6R »

you pull the part that is in the instrument cluster towards your self. Its just clipped in.

Then you will see torx bolts near the slip ring viewed from top ( birds eye persoective), and on the bottom trim underside there is an torx bolt
User avatar
Le_Combattant
Gold Member
Posts: 510
Joined: Sun Mar 07, 2021 4:04 pm
Drives: Polo 6C 1.2 TSI 90 Cup
Location: France

Re: How do I get the ignition key lock off?

Post by Le_Combattant »

dazz wrote: Fri Feb 20, 2026 7:21 am Hi
I have the VW broken ignition lock problem with the stuck key.
I am trying to remove the plastic coverings between the steering wheel and the instrument cluster.
The top half is flapping around, but held in place by the instrument cluster.
I can't figure out how to release the bottom half. I have found the Torx screw.

Any tips would be appreciated.
The top half can stay in place, with the cluster

The lower half is installed with one torx screw. When removed, you can gently pull toward the bottom the part to remove it from the steering column assy.
dazz
New
Posts: 30
Joined: Sat May 21, 2016 10:54 am
Drives: Polo 6R Comfort Line 2010
Location: New Zealand

Re: How do I get the ignition key lock off?

Post by dazz »

Hi
OK thanks for the info. That will make it easier to work on the break-off bolts. I can't turn them to loosen them off. I am using a cold chisel to try and turn them. I may have to drill them out.
Post Reply