Page 1 of 1
9n boot build
Posted: Fri Jul 22, 2005 12:02 am
by Robw53
does anyone know how to suspend the sub surrounds in the air while you fibre glass it, i heard a roomer about using chicken wire, but need alittle more help then "just use chicken wire" so if anyone can explain how to do a boot build or know of any DIY on the internet then it would be most helpful
cheers
rob
Posted: Sat Jul 23, 2005 10:55 am
by R1CH
what do you mean by sub sorrounds mate,,the box that the subs enclosed in???? ive had a pop at fiberglassing a couple of boot layouts in the past,,and while its very messy and hard work its worth it as the end results are normally stunning,
Posted: Sat Jul 23, 2005 10:45 pm
by Robw53
i mean whe bit that will be moulded into the fibreglass where the sub will be situated and fastern to.
rob
Posted: Sat Jul 23, 2005 11:44 pm
by Randall
so in other words mdf speaker rings yes?!
well you got two options mate
1. buy a sheet of mdf and cut it out yourself
2. got to autoacostics website and buy sum
Rich
Posted: Sun Jul 24, 2005 1:01 pm
by Robw53
i no i have them options but i want to know how to hold them into the place/area where you want them while you cover it with fibreglass matting.
rob
Posted: Sun Jul 24, 2005 2:59 pm
by Randall
Robw53 wrote:i no i have them options but i want to know how to hold them into the place/area where you want them while you cover it with fibreglass matting.
rob
from previous projects ive seen n read they are usually held in place with sum wood strips similar to a tripod form, then coverthe item with clothe n fibre glass away