Page 1 of 1
induction kit
Posted: Mon Mar 05, 2007 2:14 am
by NeilMobeel
hi there about to fit a bmc carbon filter and when i took the original cover off the engine and about to fit it i noticed there are two holes one at the back where i think it goes 50mm and one at the front just under 50mm what does this one do??
when i look at the cover the two holes are joined need help asap please!
Posted: Mon Mar 05, 2007 2:51 pm
by Bepe
the ones at the back dont do anything, only two holes attatch the case neil which are at the front which just basically screw into these two holes, if that is what your onabout?
Posted: Mon Mar 05, 2007 4:27 pm
by NeilMobeel
no no see the large hole nearer the front in the centre of the metal part?
that one?!
thanks for the reply though can you help further?
Posted: Mon Mar 05, 2007 4:32 pm
by Ian_R
NeilMobeel wrote:no no see the large hole nearer the front in the centre of the metal part?
that one?!
thanks for the reply though can you help further?
Thats just the top of your manifold mate, thats where the air box rest on top of it !
Posted: Mon Mar 05, 2007 4:35 pm
by NeilMobeel
so it doesnt do anythin? i dont have to put a filter on it even a small one?
sorry im really not wise lol
Posted: Mon Mar 05, 2007 4:43 pm
by Bepe
nope, you can remove that mate, all it does is sends warm air to heat the engine up quicker, iam removing mine soon
Posted: Fri Mar 16, 2007 7:22 pm
by (PoLoBoI)
hi guys cud any1 help me im trying to fit an home made induction kit i av but cud any1 tell me for the 1.0 mpi model all the pippes and that from the airbox wat do i need to do with em wen i take the air box off do i need to little air filters on the pipes i take out or wat do i do with em coz im kinda not clued up on this lot cheers if any1 cud help
