Page 1 of 1
Advice wanted on how to RE-FURBISH the starter motor???
Posted: Sat Nov 22, 2008 2:19 pm
by Petrol_Head
Any advice at all... Even if it is to not to bother and just buy a new one?
Thanks in advance,
Ben
Posted: Sat Nov 22, 2008 3:49 pm
by Torq-Al
Don't think it's difficult, strip it out & replace the brushes inside. Depends if you can get the parts cheap enough.
Just take yours to be refurbed, possibly cheaper. Or just buy a warrantied 2nd hand one!
Posted: Sat Nov 22, 2008 5:45 pm
by JarnoVWPolo6N
Most of the cases it's more then just the brushes, it can also be the axle in it's casing which isn't fitted in tight enough anymore, making it wobble. So there's a chance you need to re-new the housing.
Just get a refurbed one and swap in your old one for discount, saves you a lot of hussle and time!
Posted: Mon Nov 24, 2008 10:30 am
by Petrol_Head
Thanks, you know how dad's are...
"it just needs to be taken out and re-greased!"
I'l buy another one, easiest option and probably best.
Posted: Mon Nov 24, 2008 10:52 am
by JarnoVWPolo6N
Petrol_Head wrote:"it just needs to be taken out and re-greased!"
lol
