Page 1 of 1

RCD 200 Stock Radio

Posted: Wed Jul 01, 2020 4:21 pm
by liamchaps
I'm trying to install an Edge 12" Sub on the stock radio
I can either use High-level input or get a low-level adaptor but not sure which to go with
And how would I go about getting a remote turn on, could I use the cigarette lighter as that is controlled with the ignition
Image

Re: RCD 200 Stock Radio

Posted: Wed Jul 01, 2020 5:03 pm
by Dink
If it's got a high level input then use that (basically has the hi-lo converter built in). You could just run an extra set of wires from the rear speakers.

As for remote turn on you could just use an add a fuse adaptor in the fuse box off an ignition switched supply and stick the lowest rated fuse you can find in it.

Re: RCD 200 Stock Radio

Posted: Wed Jul 01, 2020 11:11 pm
by liamchaps
So since I don't have rear speakers I have four spare connections in the wiring harness should I use them or just splice the front speaker wires in the harness or does it not really matter?

Re: RCD 200 Stock Radio

Posted: Thu Jul 02, 2020 11:03 am
by Dink
If there's an output on the channels of the headunit use them. Probably be the easiest option.