My 16v polo... Dragon Green, UPDATE PAGE 4

[frankiepolo]

ah. well then ill just staple my lips back together then lol.

well i can lift my alloys with one finger too! certain degree off bone snapping involved but its possble... lol.

lol, got new wheels coming on friday, but might take a while to refurb and get teh way i want them!

[MiWi]

Can you upload a movie with the enginesound?

[frankiepolo]

heres a few vids....

http://uk.youtube.com/watch?v=UXvbQY9389M

http://uk.youtube.com/watch?v=4icpvfRaXL8

http://uk.youtube.com/watch?v=M4gCIbq0R9Q

http://uk.youtube.com/watch?v=Hk1ei1Xq904

[NOZ]

Very nice fella

hows the rear plate positioning going? My cars rears like yours now but im trying to somehow fit the plate slightly higher then yours is in the pics. in the bit that curves inwards! No hope; plates in the rear window at the mo!

[frankiepolo]

Very nice fella

hows the rear plate positioning going? My cars rears like yours now but im trying to somehow fit the plate slightly higher then yours is in the pics. in the bit that curves inwards! No hope; plates in the rear window at the mo!

i was thinking of doing this.....

[NOZ]

^^ I see. Personally don't like having it there lol. Perhaps if a slight indented recess was made for it?

I was gonna somehow fix it with screws where you had yours BUT on the bottomof the plate so it sits in the gap. No idea lol!!!

[frankiepolo]

^^ I see. Personally don't like having it there lol. Perhaps if a slight indented recess was made for it?

I was gonna somehow fix it with screws where you had yours BUT on the bottomof the plate so it sits in the gap. No idea lol!!!

yes ill be getting recess mate,

the way ive got my plate just now is at the bottom of bumper with 2 LED screws for the light.

[NOZ]

Lol I wanted to have 2 LED screws initially but then opted for a light reposition to the middle of the bumper. Shame it wasn't done properly but it works lol (not that the plates actually there!)

[Tim_GTi]

Mark5 rear bumper?

[frankiepolo]

Mark5 rear bumper?

im looking for a mark5 rear bumper, but if i dont get one ill just get a recess made

[sc00byd00byd00]

Heres the valver....

BMC CDA Induction kit
Ram air intake
Janspeed full s/s exhaust system
Decat
Supersprint 4-2-1 exhaust manifold
Stage 3 head
Sorg Group N Cams
Ported throttle body
Modified inlet manifold
Dastek Piggyback ECU
Dastek custom mapping
Splitfire platinum spark plugs
Magnecor 8mm Ignition Leads
Removed EGR vavle

Hiya mate. I'm curious about the above mods. what bhp & lp/ft you running at ?

I'm looking to get some more performance out of my 16v and was wondering it would be a more financially viable solution than an engine conversion.

What sort of price range was each of the mods and how difficult were they ?

[NFS]

Noticed that you are running a raceland manifold like m9. Just wanted to know how did you extend your lambda sensor and did you get any engine management lights pop up? Ive extended m9 using wires from an lambda sensor from a scrappie and used heat shrink crimps to join them but my emissions light cumz up after about 30 minz of driving.