Do you have to drill a hole from the engine bay?

PeteM · Post by **PeteM** » Wed Nov 03, 2004 11:52 am

to get wires through? or is there a hole?

Speedlaw · Post by **Speedlaw** » Wed Nov 03, 2004 2:44 pm

I fed my power cable through the hole in the bulkhead that's got all the regular wiring-loom-wires going through it, there's just enough room to squeeze one extra in there. Saves drilling!

david burton · Post by **david burton** » Wed Nov 03, 2004 7:34 pm

no don't do any drilling! there should be a few places - I did a bit in the DIY section on how to wire it up....

LJ_87 · Post by **LJ_87** » Wed Nov 03, 2004 8:18 pm

i ended up drilling a hole on the passenger side and driver side, but the driver side is easier if you are as the pollen filter and you need to remove a good bit of the dash are on the passenger side

david burton · Post by **david burton** » Wed Nov 03, 2004 8:40 pm

http://www.tigerstyle.co.uk/poloforum/v ... php?t=5097