vw sill kick/scuff plates.

Gareth_GT_Hatch · Post by **Gareth_GT_Hatch** » Thu Jan 06, 2005 5:22 pm

The ones in the pic are from a mk2 (the font is wrong for the mk3)

Maybe worth checking to see if theres an early and a late version.

genesisGT · Post by **genesisGT** » Thu Jan 06, 2005 9:46 pm

Gareth_GT_Hatch - you are to good at this game!!!

The Polo script ones are for pre 1990 car, but i checked ETKA an the sill panel is the same on the mk2 and mk2f so they would fit.

Mk2fs were only available with the plain patern (boring) so a was hoping for a set of polo script ones!

Will have to get the plain ones now as they are the only ones available. Only think i preffered about the mk2 ones is they stuck on. the later ones are screw on (dont like drilling holes in the sills = rust) so a will invest in some double sided sticky stuff out the nearest craft shop.

karl a will go halfers on the roll if you want, as there is no way we will need the full lot (gives us lots of spare stuff!), if you want.

Gareth_GT_Hatch · Post by **Gareth_GT_Hatch** » Thu Jan 06, 2005 11:17 pm

genesisGT wrote:Gareth_GT_Hatch - you are to good at this game!!!

Thank you please.

The fact that they will need to be screwed in sounds upsetting. At least theyre not expensive! so if you cant get em to fit without screws its not the end of the world.

Karl_CLCoupe · Post by **Karl_CLCoupe** » Fri Jan 07, 2005 1:51 pm

genesisGT wrote:...karl a will go halfers on the roll if you want, as there is no way we will need the full lot (gives us lots of spare stuff!), if you want.

Aye, I could bung that off with the cheque that I er... yeah, need to sort out still.

Karl.